ENG-10A + ENG-12A + L99B Power Harness

This harness is effectively a power adapter to convert your stock engine harness into a stand alone harness. All other stock wiring gets disconnected from the engine harness including the fuse boxes. Both connectors plug in under the hood, one is C1 in the diagram, the other is one of the connectors from the fuse box when you remove it (don't cut the wires!).

This harness is effectively a power adapter to convert your stock engine harness into a stand alone harness. All other stock wiring gets disconnected from the engine harness including the fuse boxes. Both connectors plug in under the hood near the fuse box. One is labeled as C1 in the diagram and the other actually plugs into the fuse box in stock form. The power harness connector is a little different from the fuse box connector (10 pin vs 6 pin), but if you line up the tab it should connect together and the latch should lock them together.

Requirements

• Starter hotwired*
• Fuel pump hotwired*
• Ignition hotwired (Power Harness)

* Pinout info for accessories can be found on the derby specs page.

Fitment

• 1987-1989 Toyota Camry