Toyota 5S 2 Row 2 Coil Derby Modded Computer V4.0 (4cyl)

***Photos updating soon.

This computer is physically modified (not tuned) for demo derby use to help keep your engine running as long as possible. It prevents limp mode and other issues for your derby car.

Features

• All extra pins removed for wider fitment
• Lights on board
  
  • Power
  • Check Engine Light
  • Injector Power
  • Injector Pulse
• Limp mode prevented
• IGF signal spoofed (feedback from ignition coils)
• Trans hot wired for 1st gear (all forward gears are now 1st)
• Possiblity of spoofing coolant temp sensor - requires special setup - see below.
• Coolant temp sensor limited (maxing out the signal is prevented)
• Works in stock cars or derby cars with a power harness.

Required Sensors

• Must be installed in a car that did not have an immo computer (must be white connectors at the computer)
• Coolant Temp Sensor (unless spoofed) - computer comes configured to use stock sensor
• Crank Sensor
• Ignition Coils (2) + Igniter to control them
• Injectors (4)
• MAP (Move vacuum port and MAP to a safe location, stock is a bad location, see the vacuum blockoff kit listing)
• TPS (better throttle responce)

Optional Sensors

• Cam Sensor (should make it run slightly better if kept stock)
• IAC (controls the engine's idle, generally best to keep stock)
• Transmission Shift Solenoids - If disconnected then the trans will perform it's normal limp mode where you have to shift all the way back to first to get first gear.

Special case for the coolant temp sensor, there's an adjustable resistor inside the computer that can be calibrated to make the computer see any temp you desire. If you set it to 200F for example, cold starts will be difficult because it will be lean. This is only intended for advanced users or I can calibrate it before shipping. I suggest keeping the temp sensor stock so it runs good cold and hot.

To calibrate the adjustable resistor, hook the computer up in a stock car, disconnect coolant temp sensor, and use an OBD2 scanner to view what the computer reports the temp sensor reading is. Adjust the screw on the brown box inside the computer until you see the temp you desire on the scanner. When installed in a derby car, be sure the temp sensor is disconnected when setup this way. Adjusting it to the lowest temp possible (resistor clicks when maxed out) will disable the coolant temp spoofing. Resistor is 12 full turns from max hot to max cold and adjustments change very slowly at first and progressively gets quicker the warmer the reading gets.

Fitment

• 1997-1999 Toyota Camry (4cyl)*
• 1999 Toyota Solara (4cyl)*

* Must be used in cars with the no immo computer (3 white connectors)

Change Log

v4.0 - New naming scheme, new circuit board design that mounts to PCB header. Combined stage 2 and stage 3 features and dropped the stage 3 features that some had issues with. New addition of a new concept for IAC spoofing and the ability to spoof coolant temp while also giving the option for using stock setup. Has 4 diag lights on board:

• Power (computer physically getting power)
• CEL (computer's self test passed)
• Injector power (lights when #1 injector receives power)
• Injector pulse (pulses when it injects fuel, tied into #1 injector)

Stage 3 - Expermental sensor spoofing, some users had issues with the setup/usage with this design. New concept of IGF signal spoofing so if a coil fails it doesn't make the engine die.

Stage 2 - Original design, prevents limp mode, extra pins removed.